Cold pressed terminals include electrical connectors, air connectors.
Release time:
2024-07-02 17:36
Source:
It is an accessory product used to realize electrical connection, and is divided into the category of connectors in industry.
Round pre-insulated terminal, cold-pressed terminal, power fittings, fork pre-insulated terminal, pin pre-insulated terminal, sheet pre-insulated terminal, bullet full-insulated terminal, long intermediate connector, short intermediate connector, round bare end, fork bare end, male and female pre-insulated terminal, tubular pre-insulated terminal, tubular bare end, pin bare end, peep series SC, DTG copper terminal, C45 special terminal.
Scope
Insulated terminals, also known as cold-pressed terminals, electronic connectors, and air connectors are all attributed to cold-pressed terminals. It is an accessory product used to realize electrical connection, and is divided into the category of connectors in industry. With the increasing degree of industrial automation and industrial control requirements more and more stringent, accurate, the amount of terminals gradually increased. With the development of the electronics industry, the use of more and more terminals, and more and more types.
In addition to the most widely used PCB board terminals, there are continuous hardware terminals, nut terminals, spring terminals and so on.
Prev
Related News
Cold pressed terminals include electrical connectors, air connectors.
It is an accessory product used to realize electrical connection, and is divided into the category of connectors in industry.
Terminal block is a kind of accessory product used to realize electrical connection
With the increasing degree of industrial automation and industrial control requirements more and more stringent
When choosing the correct terminal, you need to consider the circuit design and its application.
The plastic insulating material and conductive parts of the terminal are directly related to the quality of the terminal
The terminal is an important component for electrical connection with the wire. Terminal Type
It is an electromechanical device with the help of which wires can be terminated. It is usually composed of a metal or an alloy, but carbon or silicon can also be used. Although the wiring harness may vary depending on the system used, connectors and terminals must be used, both of which directly affect the performance and reliability of the wiring harness.
An accessory product used to make electrical connections that has no parts on a standard PCB and is often referred to as a printed circuit board Printed Wiring Board(PWB).
In order to facilitate the connection of wires, it is actually a piece of metal sheet sealed in insulating plastic. Both ends have holes for inserting wires and screws for fastening or loosening. For example, two wires sometimes need to be connected and sometimes need to be disconnected. At this time, they can be connected with terminals and disconnected at any time without welding or winding them together, which is very convenient and fast.
Service Hotline
Contact
Cao Jun: 13326875782
Email: sales05@shangtong8.com
Chen Miao: 13538681033
Email: sales01@shangtong8.com
Zhang Xiujian: 13580859255
Email: sales02@shangtong8.com
Yu Fuping: 13532665722
Email: sales04@shangtong8.com
Han Running: 13537189433
Email: sales03@shangtong8.com
Wang Fan: 18024773968
Email: sales06@shangtong8.com
Address: No. 1, Lane 1, Xilong Road, Xicheng, Hengli Town, Dongguan City, Guangdong Province
sweep
